Cam swap girls adrianne curry dating

The company specifies a 1.60 roller rocker with the spring requirements as shown.

The "Recommended RPM Range" defines streetability with a 2,500-6,500-rpm band that doesn't drop off or hesitate, unless you have the sense to get your foot off the loud pedal.

Through years of trial and error, the gang at Paul's has found the Steeda stick to be one of the best for the picky stock computer found in '94-'95 GT Mustangs.

Tom's convertible is much more of a street cruiser than a drag racer, so you can use that tip-off as an indication of which side of the manners-versus-power scale he leaned toward.

On the dyno, this combination belted out 471.6 rwhp and 451.7 rwtq with a mild tune on pump gas.

Cam swap girls-16

Prompted by a previous 5.0&SF story, both owners asked us to follow along as they did real-world cam swaps. It is likely the company has experimented with-and designed-cams for your exact collaboration of parts. Tom enlisted the help of several of the country's top cam companies and engine builders to get their secrets, experiences, and predictions about different combinations with the right camshaft, calling the shots on four popular 5.0 variations. Mike believed the only things missing from the story were some actual cam installations with typical combinations such as his.Michael's '95 GT features a 105,000-mile stock short-block; unported GT-40P heads with stock valves; an unported Cobra intake; a stock 60mm throttle body; a 75mm Pro-M bullet mass air; MAC P-head-specific 151/48-inch short-tube headers, a MAC off-road X-pipe; and a stuffy, stock after-cat.The five-speed car has 3.73 gearing and a Ford Racing Performance Parts Extender to help tune the stock computer a bit.Without a rollbar, track testing is a ways off, but expect something in the low 11s at more than 125 mph with sticky tires."I'm very pleased with the results of the No. "It has run great on the street, even with the A/C on, and I have no regrets. It starts to pull away from the stock bumpstick at 3,000 rpm, then it really takes off at 3,500.It continues to pull hard until 5,500 with my combo. It has a mild chop at around a 750-rpm idle-pretty smooth, but enough to know it has a cam.

Leave a Reply